 |
胶水公司
| 联系人：王小姐
女士 (主管) |
| 电 话：021-51693135 |
手 机：13052326431  |
  |
|
 |
|
| HYSOL KL-G150电子胶水/塑封胶水/汉高乐泰胶水/塑封方案 |
HYSOL KL-G150电子胶水/塑封胶水/汉高乐泰胶水/塑封方案
技术服务热线：021-51693135 / 021-22818476
乐泰 HYSOL KL G150 has been formulated to provide the bestpossible moldability and as wide a molding latitude as possible.
Although molding and curing conditions will vary from situation tosituation, recommended starting ranges are shown above.
TYPICAL PROPERTIES OF CURED MATERIALAll measurements taken at 25 °C unless otherwise noted.
All physical, electrical and analytical measurements taken on specimens curedfor 2 minutes @ 175 °C with post cure of 6 hours at 175 °C, unlessother wise specified.
Physical Properties:Coefficient of Thermal Expansion , ppm/°C:Below Tg 18Above Tg 60Glass Transition Temperature, °C 165
Specific Gravity 1.92StorageStore product in the unopened container in a dry location.Storage information may be indicated on the product containerlabeling.Powder Storage - Powder or preforms should be stored at 5oCor below, in closed containers.
After removal from coldstorage, the material MUST be allowed to come to roomtemperature, in the sealed container, to avoid moisturecontamination.
The suggested waiting time for a standard 15kg carton box is 24 hours
乐泰 HYSOL KL G150已经配制成提供*佳可塑性和尽可能宽的成型纬度。
虽然成型和固化条件将根据情况设置而有所不同，但推荐的起始范围如上所示。固化材料的特性在25°C下进行所有测量除非另有说明。
所有身体，除非另有规定，否则试样在175℃下固化2分钟后进行电气和分析测量，除非另有规定，物理性能：热膨胀系数，ppm /℃：低于Tg 18Ab Tg 60玻璃化转变温度， °C 165比重1.92储存产品在未开封的集装箱中，在干燥的位置。
储存信息可能在产品容器标签上显示。
粉末储存 - 粉末或预制件应存放在5oC以下，密闭的容器中。
从冷藏箱中取出后，必须在密封容器中使材料达到室温，以避免水分污染。
标准15kg纸箱的建议等待时间为24小时 |
 |
| |
|
|
 |
|
|
免责声明：以上所展示的信息由会员自行提供，内容的真实性、准确性和合法性由发布会员负责，www.qy6.com对此不承担任何责任。如有侵犯您的权益，请来信通知删除。