STYCAST U2500电子组装/工业胶水/电子组装胶水/工业用胶
技术服务热线：021-51693135 / 021-22818476
乐泰 STYCAST U 2500 is an encapsulant designed for
transformer, PCB's and other insulation applications. It allows
for complete impregnation when used either on small slightly
wound coils or large castings.
TYPICAL PROPERTIES OF UNCURED MATERIAL
Part A Properties
Viscosity @ 25 °C, mPa∙s (cP) 12,500
Density , g/cm3 1.5
Shelf Life @ 18 to 25°C, months 6
Flash Point - See SDS
Part B Properties
Viscosity @ 25 °C, mPa∙s (cP) 0.05
Density , g/cm3 1.25
Flash Point - See SDS
Mixed Properties
Mixed Viscosity @ 25°C, mPa•s (cP) 6,000
Pot Life @ 25 °C, hours 2
Flash Point - See SDS
TYPICAL CURING PERFORMANCE
Cure Schedule
24 hours @ 25°C or
4 hours @ 60°C
Complete cure at room temperature will be obtained after 2 to 3days.
A post cure of 2 hours @ 100 to 120°C will improve final
end-properties.
Storage
This material is moisture sensitive and must be stored in tightly closed
containers at the recommended storage temperature. Partially used
containers should be blanketed with dry nitrogen before resealing.
Store product in the unopened container in a dry location. Storage
information may be indicated on the product container labeling.
Optimal Storage : 18 to 25 °C
乐泰 STYCAST U 2500是一种专门设计的密封剂
变压器，PCB等绝缘应用。它允许
完全浸渍时使用时要小些
缠绕线圈或大型铸件。
固化材料的典型特性
部分A属性
25℃时的粘度，mPa•s（cP）12,500
密度，g /cm31.5
保质期为18至25°C，月6
闪点 - 见SDS
B部分属性
粘度@ 25℃，mPa•s（cP）0.05
密度，g /cm31.25
闪点 - 见SDS
混合属性
混合粘度@ 25℃，mPa•s（cP）6000
25°C，小时2
闪点 - 见SDS
典型的固化性能
治愈时间表
25°C或24小时
60℃下4小时
2〜3天后，室温下完全固化。
在100至120°C的2小时后固化将提高*终效果
终端属性。
存储
这种材料是潮湿敏感的，必须密封储存
容器在推荐的储存温度。部分使用
容器应覆盖干燥氮气， |
免责声明：以上所展示的信息由会员自行提供，内容的真实性、准确性和合法性由发布会员负责，www.qy6.com对此不承担任何责任。如有侵犯您的权益，请来信通知删除。