Loss of Input Clock (NMI Watchdog Function)The2806xdevicesmaybeclockedfromeitheroneoftheinternalzero-pinoscillators(INTOSC1/INTOSC2), the on-chip crystal oscillator, or from an external clock input. Regardless of theclock source, in PLL-enabled and PLL-bypass mode, if the input clock to the PLL vanishes, the PLL willissue a limp-mode clock at its output. This limp-mode clock continues to clock the CPU and peripherals ata typical frequency of 1–5 MHz.When the limp mode is activated, a CLOCKFAIL signal is generated that is latched as an NMI interrupt.Depending on how the NMIRESETSEL bit has been configured, a reset to the device can be firedimmediately or the NMI watchdog counter can issue a reset when it overflows. In addition to this, theMissing Clock Status (MCLKSTS) bit is set. The NMI interrupt could be used by the application to detectthe input clock failure and initiate necessary corrective action such as switching over to an alternativeclock source (if available) or initiate a shut-down procedure for the system.If the software does not respond to the clock-fail condition, the NMI watchdog triggers a reset after apreprogrammed time interval. Figure 2-15 shows the interrupt mechanisms involved.
CPU-Watchdog ModuleThe CPU-watchdog module on the 2806x device is similar to the one used on the 281x/280x/283xxdevices. This module generates an output pulse, 512 oscillator clocks wide (OSCCLK), whenever the 8-bitwatchdog up counter has reached its maximum value. To prevent this, the user must disable the counteror the software must periodically write a 0x55 + 0xAA sequence into the watchdog key register that resetsthe watchdog counter. Figure 2-16 shows the various functional blocks within the watchdog modul |
 |
|
|
手机站
您当前位置是：产品大全 >> 电子元器件 >>
集成电路(IC)
免责声明：以上所展示的信息由会员自行提供，内容的真实性、准确性和合法性由发布会员负责，www.qy6.com对此不承担任何责任。如有侵犯您的权益，请来信通知删除。
联系信息
