HZS商品混凝土搅拌站养护周期划分:
HZS commercial concrete mixing station maintenance cycle division:
日常维护与保养1.每班开机前应做工作1) 检查各骨料仓是否装满.
Daily maintenance and maintenance 1. before the start of each class should do the work 1) to check whether the aggregate is full.
2) 检查水池水位情况,将水池装水至上限位.
2) check the water level of the pool and limit the water to the top of the pool.
3) 检查各气路是否有漏气、漏水现象,如有,则及时拆卸、清洗、更换,直至 不漏为止.有无软管破损、老化.
3) check whether there is leakage and leakage of each gas road. If there is, remove, clean and replace it in time until no leakage.
4) 检查各气动蝶阀动作是否准确到位,若关闭不严,应及时调整好至关闭良好.
4) check whether the action of each pneumatic butterfly valve is accurately in place, if the closure is not strict, it should be adjusted well to good close in time.
5) 检查各减速箱内油量是否到位,油量不得过多或过少(按减速机说明书要 求).
5) check whether the amount of oil in the reducer is in place, the amount of oil should not be too much or too little (according to the requirements of the reducer's manual).
6) 检查螺旋机各加油点是否已加润滑油脂.
6) check whether the oil filling points of the screw machine have been added to grease.
7) 检查各输送皮带松紧是否合适、跑偏是否严重,若不行则要求先空转运行并 调整后部张紧装置至合适,注意此时应关闭骨料仓门.
7) check whether the belt tightness is suitable and whether the deviation is serious. If not, then it is required to run around first and adjust the rear tensioning device to the right place. Pay attention to closing the aggregate bin door at this time.
8) 检查皮带机托辊转动是否灵活,否则应拆下清洗或更换内轴承,直至转动灵 活.
8) check the flexibly of the rollers of the belt conveyor, otherwise the inner bearings should be removed or replaced until the rotation is flexible.
9) 检查气动两联件中过滤器的积水情况,积水量多需放出,油雾气器中油量是 否够,不够则应加够,否则将影响气路的正常使用.
9) check the accumulating water of the filter in the two pneumatic parts. The amount of water needed to be released and the amount of oil in the oil mist device is enou |
 |
|
|
手机站
您当前位置是：产品大全 >> 建筑、建材 >>
水泥及制品
免责声明：以上所展示的信息由会员自行提供，内容的真实性、准确性和合法性由发布会员负责，www.qy6.com对此不承担任何责任。如有侵犯您的权益，请来信通知删除。
联系信息